Dynamic tensile testing of sheet metal - Archive ouverte HAL Accéder directement au contenu
Article Dans Une Revue Journal de Physique IV Proceedings Année : 2000

Dynamic tensile testing of sheet metal

Résumé

The testing of sheet metal at high strain rates requires the use of the SHPB set-up. This technique provides satisfactory results as far as the compression and shear are concerned. A modified SHPB set-up is presented here, which extends the scope of this technique to the tensile loading of sheet metals. In this case, many measurement problems arise due to the way in which the specimen is connected to the bars, which never completely prevents unexpected slipping and is liable to induce interference waves due to an impedance mismatch. The technique described here was based on the "hat specimen" technique proposed by Lindholm [l]. A two-dimensional "hat shaped" specimen is subjected to compression loading. A tensile state is induced in a symmetrically necked area, where higher strains are concentrated. Connecting supports of an appropriate shape are attached to the bars. They have the same impedance as that of the bars to avoid the occurrence of any interference waves. The "hat" shape prevents sliding, and to ensure perfect initial contact conditions, the complete system is elastically pre-stressed. A special method of wave analysis is then used to determine the forces and displacements occurring at the specimen ends from the strain signals recorded in the bars.
Fichier principal
Vignette du fichier
Mouro2000.pdf (596.49 Ko) Télécharger le fichier
Origine : Fichiers produits par l'(les) auteur(s)
Loading...

Dates et versions

hal-00111309 , version 1 (22-06-2018)

Identifiants

Citer

P. Mouro, Gérard Gary, Han Zhao. Dynamic tensile testing of sheet metal. Journal de Physique IV Proceedings, 2000, 10, pp.149-153. ⟨10.1051/jp4:2000925⟩. ⟨hal-00111309⟩
108 Consultations
200 Téléchargements

Altmetric

Partager

Gmail Facebook X LinkedIn More