Graphene oxide-induced CuO reduction in TiO2/CaTiO3/Cu2O/Cu composites for photocatalytic degradation of drugs via peroxymonosulfate activation
Résumé
Contamination of water bodies is a global environmental and human health issue. Conventional water treatment systems cannot efficiently eliminate organic contaminants, particularly drugs. Photocatalysis is a promising, environmentally friendly oxidation process for the removal of such compounds. A key point is the choice of material to be used as photocatalyst. Here, TiO2/CaTiO3/Cu2O/Cu composites were fabricated by adding different amounts (x) of graphene oxide (GO) (x wt% = 1, 3, and 5 %) to CaCu3Ti4O12 powder using the solid-state synthesis method. The produced pellets were sintered under inert nitrogen atmosphere at 1100 °C for 3 h. X-ray diffraction analysis showed that the Cu metal amount was increased upon GO addition, and the UV–Vis diffuse reflectance spectroscopy showed that the spectral response was extended to the visible range. Then, high performance liquid chromatography assessment of paracetamol degradation by a photocatalytic cell using TiO2/CaTiO3/Cu2O/Cu composites with different GO amounts showed that the removal efficiency was increased upon introduction of 0.5 mM peroxymonosulfate (PMS) as active component to generate radical dotSO4‾ radicals. After 3 h under visible light, 96 % of 10 ppm paracetamol was degraded by the composite with 3 % of GO (1 cm2 surface photocatalyst) compared with 50 % by the composite without GO in the same experimental conditions (PMS in 210 mL of aqueous solution). Free radical trapping and the acute toxicity of potential degradation by-products were also investigated. Our results indicate that TiO2/CaTiO3/Cu2O/Cu with 3 % GO displays long-term stability and durability for the photocatalytic removal of pharmaceutical pollutants from wastewater.