A novel hydraulic bulge test device was developed to evaluate high temperature biaxial stress-strain curves of quenchable boron steel sheets. The work mainly focuses on the resistance heating designed to assure a homogeneous temperature field in the dome area of the circular blank where the hydraulic pressure will be applied. The practical hot stamping conditions, including the heating and cooling steps, were reproduced to perform hydraulic bulge tests on the Usibor and REG;1500P steel for a temperature range between 700 to 900 degrees C, after an austenization step at 900 and DEG;C. Stress-strain curves were obtained from these expansion tests using the data extracted with a laser profilometer, due to the difficulties associated with the use of Digital Image Correlation at such high temperatures. Although the profilometer is a compromise solution, the comparisons between tensile and biaxial stress-strain results enable to verify the feasibility of the new device for the evaluation of the stress-strain curves at a high temperature in a biaxial state. The results point-out that, besides the difficulties with the acquisition of the strain fields and in the strain-rate control, there are also challenges in the interpretation of the metallurgical evolutions that can occur during the tests, which can affect the biaxial flow curves.