Influence of the Length of a Cylinder on its Aeolian Tone Level: Measurement and Modelling - Archive ouverte HAL Accéder directement au contenu
Communication Dans Un Congrès Année : 2021

Influence of the Length of a Cylinder on its Aeolian Tone Level: Measurement and Modelling

C. Noûs

Résumé

The tonal noise generated by the flow over elongated cylinders is measured using microphones in the anechoic wind tunnel BETI of Institut Pprime. The effect of the length to diameter ratio of the cylinder is assessed by varying the diameter from 6 mm to 20 mm within the constant width (750mm), open jet, test section. The velocity is varied from 10 to 40 m/s, leading to a Reynolds number range of about 4,000 ­ 53,000. A proper normalization is needed to obtain a good collapse of experimental data from nearly 10 studies on the same evolution in 3 steps: for very short cylinders, the tone level does not depend on the length; for semi-long cylinders, it follows the fourth power of the length to diameter ratio; for very long cylinder, the length's influence vanishes in the form of a sound level asymptote. This sigmoidal evolution is noticed for both the circular section and the square section cylinders, and questions the classical modelling of the aeroacoustic process using compact, coherent segments of cylinder associated with a coherence length to account for spanwise phase loss. Literature data from numerical simulation or experiment using end-plates are included in the analysis too.
Fichier principal
Vignette du fichier
Draft_Content_427847613p5808.pdf (1.53 Mo) Télécharger le fichier
Origine : Fichiers produits par l'(les) auteur(s)

Dates et versions

hal-04220829 , version 1 (28-09-2023)

Identifiants

Citer

W. Pinto, F. Margnat, C. Noûs. Influence of the Length of a Cylinder on its Aeolian Tone Level: Measurement and Modelling. 14th WCCM-ECCOMAS Congress, Jan 2021, Virtual conference, France. ⟨10.23967/wccm-eccomas.2020.178⟩. ⟨hal-04220829⟩
3 Consultations
1 Téléchargements

Altmetric

Partager

Gmail Facebook X LinkedIn More