Simulation and Optimization of Optical Fiber Irradiation with X-rays at Different Energies - Archive ouverte HAL Accéder directement au contenu
Article Dans Une Revue Radiation Année : 2023

Simulation and Optimization of Optical Fiber Irradiation with X-rays at Different Energies

Arnaud Meyer
Damien Lambert
Adriana Morana
Aziz Boukenter

Résumé

We investigated the influence of modifying the voltage of an X-ray tube with a tungsten anode between 30 kV and 225 kV, and therefore its photon energy spectrum (up to 225 keV), on the Total Ionizing Dose deposited in a single-mode, phosphorus-doped optical fiber, already identified as a promising dosimeter. Simulation data, obtained using a toolchain combining SpekPy and Geant4 software, are compared to experimental results obtained on this radiosensitive optical fiber and demonstrate an increase of the deposited dose with operating voltage, at a factor of 4.5 between 30 kV and 225 kV, while keeping the same operating current of 20 mA. Analysis of simulation results shows that dose deposition in such optical fibers is mainly caused by the low-energy part of the spectrum, with 90% of the deposited energy originating from photons with an energy below 30 keV. Comparison between simulation and various experimental measurements indicates that phosphosilicate fibers are adapted for performing X-ray dosimetry at different voltages.

Dates et versions

hal-04038632 , version 1 (21-03-2023)

Identifiants

Citer

Arnaud Meyer, Damien Lambert, Adriana Morana, Philippe Paillet, Aziz Boukenter, et al.. Simulation and Optimization of Optical Fiber Irradiation with X-rays at Different Energies. Radiation, 2023, 3 (1), pp.58-74. ⟨10.3390/radiation3010006⟩. ⟨hal-04038632⟩
11 Consultations
0 Téléchargements

Altmetric

Partager

Gmail Facebook X LinkedIn More