Heats of Adsorption of CO on a Cu/Al2O3Catalyst Using FTIR Spectroscopy at High Temperatures and under Adsorption Equilibrium Conditions - Archive ouverte HAL Accéder directement au contenu
Article Dans Une Revue Journal of Physical Chemistry B Année : 2000

Heats of Adsorption of CO on a Cu/Al2O3Catalyst Using FTIR Spectroscopy at High Temperatures and under Adsorption Equilibrium Conditions

Résumé

The adsorption of CO on a 4.7% Cu/Al2O3 catalyst either reduced or oxidized is studied using the FTIR spectra recorded at adsorption temperatures Ta in the range 298-740 K and with two constant partial pressures Pa (10 3 and 10 4 Pa). On the reduced solid and at Ta = 300 K a single IR band is detected at 2092 cm-1 ascribed to a linear CO species (denoted by L0) on Cu particles. The FTIR spectra lead to the determination of the evolution of the coverage of the L0 species with Ta for the two CO pressures. In the temperature range 380 K > Ta > 480 K, the curves = f(Ta) for the two CO pressures are in very good agreement with Temkin's adsorption model. Moreover, it is shown that, in the range 300-600 K, the curves are in agreement with an adsorption model considering (a) an immobile adsorbed species and (b) a linear decrease in the heat of adsorption with the coverage in the range 0-1. This leads to the determination of the heat of adsorption E , at various coverages from E0 = 82 kJ/mol at = 0 to E1 = 57 kJ/mol at = 1. It is shown that these values are similar to those obtained using the Clausius-Clapeyron equation. On the oxidized Cu/Al2O3 catalyst, an IR band is detected at 2120 cm-1 at 300 K. Its intensity increases either with time on stream in 1% CO/He or with increase in Ta. This IR band is ascribed to a linear CO species (denoted by L1) on Cu + sites and the increase in its intensity is assigned to the reduction of the copper oxide surface. The maximum in the superficial concentration of the Cu + sites is obtained after reduction in 1% CO/He at 473 K. This allows the determination of the heats of adsorption of L1 species at various coverages which linearly vary with from E'0 = 115 kJ/mol at = 0 to E'1 = 58 kJ/mol at = 1. The two L species are present simultaneously on the surface for an incomplete reduction of the solid, and it is shown that this does not significantly affect the heats of adsorption of the two adsorbed species. Moreover, the aging of the reduced catalyst has no effect on the heats of adsorption of the L0 and L1 species but leads to the detection of a new IR band at 2003 cm-1 ascribed to a bridged CO species on Cu sites. The heat of adsorption of this species is strongly higher than those of the two L species varying with the coverage from 130 kJ/mol at = 0 to 78 kJ/mol at = 1. Finally, it is shown that the heats of adsorption of the L0 and L1 species are in accord with the literature data on the stability of the two adsorbed species in the course of a desorption at room temperature.

Domaines

Catalyse
Fichier principal
Vignette du fichier
Heats of adsorption of CO on a CuAl2O3.pdf (185.78 Ko) Télécharger le fichier
Origine : Fichiers produits par l'(les) auteur(s)

Dates et versions

hal-03106888 , version 1 (12-01-2021)

Identifiants

Citer

Olivier Dulaurent, Xavier Courtois, Vincent Perrichon, Daniel Bianchi. Heats of Adsorption of CO on a Cu/Al2O3Catalyst Using FTIR Spectroscopy at High Temperatures and under Adsorption Equilibrium Conditions. Journal of Physical Chemistry B, 2000, 104 (25), pp.6001 - 6011. ⟨10.1021/jp9943629⟩. ⟨hal-03106888⟩
17 Consultations
176 Téléchargements

Altmetric

Partager

Gmail Facebook X LinkedIn More