The local mechanical properties of a weld zone, in a 6061-T6 aluminium alloy subjected to the modified indirect electric arc technique have been studied. The mechanical properties of the base metal, the weld metal and the heat affected zone were determined by means of usual and instrumented indentation testing, as well as micro-traction testing. To analyse the heat input effect resulting from the welding process, the evolution of the weld zone size was evaluated by means of classical indentation under a constant applied load. The results were presented using a Vickers hardness map representation. This allows monitoring exact hardness variation while leading to the identification of the different zones of the welded joint. Instrumented indentation testing was carried out to determine the local mechanical properties, such as the yield stress, the bulk modulus and the strain-hardening exponent. Obtained results are compared to those derived from tensile tests conducted on micro-specimen cuts taken from the weld zone. It was observed that yield stress values are directly comparable for indentation and micro-traction experiments. As for the elastic properties, no comparison was possible since the bulk modulus is measured by indentation, whereas it is the Young's modulus by tensile test. The micro-traction testing seems to be more sensitive to represent the work hardening of a material since the corresponding exponent is found to be constant by instrumented indentation.