Thermal conductivity calibration for hot wire based dc scanning thermal microscopy - Archive ouverte HAL Accéder directement au contenu
Article Dans Une Revue Review of Scientific Instruments Année : 2003

Thermal conductivity calibration for hot wire based dc scanning thermal microscopy

Résumé

Thermal conductivity characterization with nanoscale spatial resolution can be performed by contact probe techniques only. The technique based on a hot anemometer wire probe mounted in an atomic force microscope is now a standard setup. However, no rigorous calibration procedure is provided so far in basic dc mode. While in contact with the sample surface, the electrical current I injected into the probe is controlled so that electrical resistance or the wire temperature is maintained by the Joule effect. The variation in current is assumed to be linearly related to the heat flux lost towards the sample and traditional calibration is carried out by relating the thermal conductivity of a set of samples to the measured current I. We provide analytical and numerical thermal modeling of the tip and sample to estimate the key heat transfer in a conductivity calibration procedure. A simple calibration expression is established that provides thermal conductivity as a function of the probe current or voltage measured. Finally, experimental data allow us to determine the unknown quantities of the parametric form obtained, i.e., the mean tip-sample contact radius and conductance.
Fichier non déposé

Dates et versions

hal-00131220 , version 1 (15-02-2007)

Identifiants

  • HAL Id : hal-00131220 , version 1

Citer

Sébastian Voltz, Stéphane Lefevre, Catherine Fuentes, Nathalie Trannoy. Thermal conductivity calibration for hot wire based dc scanning thermal microscopy. Review of Scientific Instruments, 2003, 74 n° 4, pp.1-6. ⟨hal-00131220⟩
86 Consultations
0 Téléchargements

Partager

Gmail Facebook X LinkedIn More