Pré-Publication, Document De Travail Année : 2025

Design and Fabrication Of Multiplexed One-Port SAW Resonators On A Single Chip

Résumé

Shear horizontal surface acoustic wave (SH-SAW) sensors are considered as a viable option for label-free, sensitive, real-time, and cost-effective detection. In this paper, we present the design, the fabrication and the characterization of multiplexed SAW sensors based on a single chip SAW resonator. Operating near the industrial, scientific and medical (ISM) bands, resonators were microfabricated on 42.75° Y (ST) cut Quartz. This substrate was selected due to its traditional association with temperature stability in the design of SAW devices. Parameters like aperture, number of interdigitated electrode (IDT) pairs, IDT wavelengths, and number of reflectors were studied experimentally to enhance electrical responses. Resonance frequency, quality factor and electromechanical coupling were extracted through impedance measurements and fitted with a modified Butterworth-Van Dyke (MBVD) model. Based on these results, we propose a novel design for a multi-frequency device that can serve as a single electronic nose for complex gases detection.

Fichier principal
Vignette du fichier
Design and Fabrication Of Multiplexed One-Port SAW Resonators On A Single Chip.pdf (1.32 Mo) Télécharger le fichier
Origine Fichiers produits par l'(les) auteur(s)
Licence

Dates et versions

hal-05098864 , version 1 (06-06-2025)

Licence

Identifiants

Citer

Alexandre Westrelin, Pierre Debavelear, Mathieu Lefevbre, Nour Abdallah, Kamal Lmimouni, et al.. Design and Fabrication Of Multiplexed One-Port SAW Resonators On A Single Chip. 2025. ⟨hal-05098864⟩
278 Consultations
497 Téléchargements

Altmetric

Partager

  • More