On the difference in material structure and fatigue properties of polyamide specimens produced by fused filament fabrication and selective laser sintering - Archive ouverte HAL Accéder directement au contenu
Article Dans Une Revue International Journal of Advanced Manufacturing Technology Année : 2020

On the difference in material structure and fatigue properties of polyamide specimens produced by fused filament fabrication and selective laser sintering

Résumé

The present paper describes the influence of both flexure quasi-static and fatigue loading on polyamide 12 (PA12) specimens fabricated by fused filament fabrication (FFF) and selective laser sintering (SLS) processes. Rectangular prisms (ISO 178:2010) of polymer were printed and tested under sinusoidal three-point bending fatigue loading at a frequency of 5 Hz. The differences in porosity, surface roughness, and degree of crystallinity are systematically measured and linked to the mechanical fatigue properties. Fatigue analysis in the visco-elastic domain of the polymer is fully described, from fatigue behavior to energy analysis. Here, we have shown that the fatigue properties of the FFF specimens are found to be higher than those of the SLS specimens, despite their lower degree of crystallinity (more than four times). The presence of pores and their growth during fatigue tests in the sintered PA12 specimen seem to be responsible. The fatigue loss factor analysis shows that at lower stress levels, PA12 material reveals its characteristic slight visco-elastic dissipation and heating as its lifetime was exhausted. Also, the obtained results of additively manufactured PA12 were compared with those of materials obtained by injection molding (IM) and extrusion techniques. The quasi-static flexural properties of PA12 obtained by FFF and SLS processes reveal better character istics compared to IM and extruded specimens. However, the fatigue properties of the SLS-processed polymer are 24% and 40% less than those of materials obtained by IM and extrusion.
Fichier principal
Vignette du fichier
LAMPA_IJAMT_2020_Terekhina.pdf (5.53 Mo) Télécharger le fichier
Origine : Fichiers produits par l'(les) auteur(s)

Dates et versions

hal-03470886 , version 1 (08-12-2021)

Identifiants

Citer

Svetlana Terekhina, Tatiana Tarasova, Sergey Egorov, Laurent Guillaumat, Lamine Hattali. On the difference in material structure and fatigue properties of polyamide specimens produced by fused filament fabrication and selective laser sintering. International Journal of Advanced Manufacturing Technology, 2020, 111, pp.93-107. ⟨10.1007/s00170-020-06026-x⟩. ⟨hal-03470886⟩
22 Consultations
171 Téléchargements

Altmetric

Partager

Gmail Facebook X LinkedIn More