In response to excitation of skeletal muscle fibers, trains of action potentials induce changes in the configuration of the dihydropyridine receptor (DHPR) anchored in the tubular membrane which opens the Ca2+ release channel in the sarcoplasmic reticulum membrane. The DHPR also functions as a voltage-gated Ca2+ channel that conducts L-type Ca2+ currents routinely recorded in mammalian muscle fibers, which role was debated for more than four decades. Recently, to allow a closer look into the role of DHPR Ca2+ influx in mammalian muscle, a knock-in (ki) mouse model (ncDHPR) carrying mutation N617D (adjacent to domain II selectivity filter E) in the DHPRα1S subunit abolishing Ca2+ permeation through the channel was generated [Dayal et al., 2017]. In the present study, the Mn2+ quenching technique was initially intended to be used on voltage-clamped muscle fibers from this mouse to determine whether Ca2+ influx through a pathway distinct from DHPR may occur to compensate for the absence of DHPR Ca2+ influx. Surprisingly, while N617D DHPR muscle fibers of the ki mouse do not conduct Ca2+, Mn2+ entry and subsequent quenching did occur because Mn2+ was able to permeate and produce L-type currents through N617D DHPR. N617D DHPR was also found to conduct Ba2+ and Ba2+ currents were strongly blocked by external Ca2+. Ba2+ permeation was smaller, current kinetics slower and Ca2+ block more potent than in wild-type DHPR. These results indicate that residue N617 when replaced by the negatively charged residue D is suitably located at entrance of the pore to trap external Ca2+ impeding in this way permeation. Because Ba2+ binds with lower affinity to D, Ba2+ currents occur, but with reduced amplitudes as compared to Ba2+ currents through wild-type channels. We conclude that mutations located outside the selectivity filter influence channel permeation and possibly channel gating in a fully differentiated skeletal muscle environment.