Modeling of high speed RTM injection with highly reactive resin with on-line mixing - Archive ouverte HAL Accéder directement au contenu
Article Dans Une Revue Composites Part A: Applied Science and Manufacturing Année : 2011

Modeling of high speed RTM injection with highly reactive resin with on-line mixing

Résumé

Structural composite manufacturing in automotive industry tends towards short cycle times for being competitive with other material solutions. Development towards resin transfer molding process can be considered when highly reactive resin with short curing cycle is used. Mixing of the resin system components is then held at the mold inlet to reduce catalyzed resin life time. Cure kinetics and viscosity changes induced during filling are thus to be taken into account when injection process simulation is considered. In the case of on-line mixing of resin components, viscosity and degree of cure of the first injected resin droplets are not the same than for the following ones. This topic will be addressed here for mixed constant flow rate and pressure injection schemes. A solution that could be implemented in a RTM simulation package was developed and validated with an analytical solution and on a complex shape automotive part demonstrator.
Fichier principal
Vignette du fichier
Deleglise2011.pdf (602.31 Ko) Télécharger le fichier
Origine Fichiers produits par l'(les) auteur(s)

Dates et versions

hal-01773157 , version 1 (14-07-2024)

Identifiants

Citer

Mylène Deléglise, Philippe Le Grognec, Christophe Binetruy, Patricia Krawczak, Bruce Claude. Modeling of high speed RTM injection with highly reactive resin with on-line mixing. Composites Part A: Applied Science and Manufacturing, 2011, 42 (10), pp.1390-1397. ⟨10.1016/j.compositesa.2011.06.002⟩. ⟨hal-01773157⟩
19 Consultations
0 Téléchargements

Altmetric

Partager

Gmail Mastodon Facebook X LinkedIn More